1. Close all doors

2. Insert key into ignition

3. Hold down the power UNLOCK button on the driver's door panel, continue to
    hold down until instructed to release in step 9.

4. Perform steps 5 through 8 in a fairly rapid succession.

5. Turn the ignition to the ON position (as far as you can go without starting the
     engine.)

6. Turn the ignition to the OFF position.

7. Turn the ignition to the ON position (as far as you can go without starting the
    engine.)

8. Turn the ignition to the OFF position.

9. Release the power UNLOCK button on the door panel. The vehicle should
    respond by door locks locking and unlocking automatically. (If locks do not
    cycle after you let go, not before you let go of the unlock button, then the
    vehicle has not entered programming mode and you must start procedure
    over. Remove key from ignition, open drivers door
    and return to step 1 ). If the locks do cycle automatically then proceed to
    step 10.

10. Hold down the LOCK and UNLOCK buttons on the remote until the doors
      lock and unlock. This may take up to 30 seconds.

11. Repeat step 10 NOW for each additional remote. (Including any existing
      remotes).

12. Turn the ignition to the ON position to exit the programming mode.

13. Test remote(s).