07 is a split year - please verify
2003-2007 with the Old Body Style 1. Close all vehicle doors. 2. Insert the key into the ignition. 3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold 4. Perform steps 5 through 8 in fairly rapid succession. 5. Turn the ignition switch to the ON position (as far as you can go without starting the 6. Turn the ignition switch to the OFF position. 7. Turn the ignition switch to the ON position. 8. Turn the ignition switch to the OFF position. 9. Release the power unlock button on the door panel. The vehicle will lock and unlock 10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until 11. Repeat step 10 NOW for each additional transmitter (including any existing 12. Turn the ignition switch to the ON position in order to exit the transmitter programming Use this Procedure for Vehicles with 1. Insert Key and turn to ON position so you can access Driver Information Center To access this display, the vehicle must be in Park (P) with key in the on position (as far 2. Press and hold the trip odometer reset stem for three seconds. 3. Press and hold the lock and unlock buttons on the first keyless remote at the same 4. To program additional remotes at this time repeat step 3. 5. To exit programming mode turn key off and remove key. Can I Program an ignition key for this vehicle?
down until instructed to release in step 9.
engine).
the doors automatically.
the door locks and unlocks.
This step may take up to 30 seconds.
transmitters).
mode.
2007 New Body Style
Driver Information Center Buttons
This information is in your Owners Manual in the
Drivers Information Center Section.
2. Press the vehicle information button until
PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until
REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the keyless remote at the same
time for approximatley 15 seconds. A chime will sound indicating that the remote is
programmed.
5. To program additional remotes at this time repeat step 4.
This vehicle can have a maximum of eight remotes programmed
6. To exit programming mode turn key off and remove key.
Test remote(s).
Use this Procedure for Vehicles without
Drivers Information Center Buttons
as you can go without cranking engine)
1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
The message REMOTE KEY LEARNING ACTIVE will display
time for approximately 15 seconds. A chime will sound indicating that the remote is
programmed.
This vehicle can have a maximum of eight remotes programmed.
Test remote(s).
Yes, Contact us.
