Programming Instructions:

1.   Insert key in ignition and leave in the OFF position

2.    Locate the Data Link Port. It is located under dash drivers side. Be sure you know
      which pins are 8 and 4.   

3.      Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a 
        suitable jumper wire (leave the jumper wire connected throughout the programming 
        procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond 
        by locking and unlocking the doors to signify entering of programming mode.

4.    Close doors.

5.   Turn ignition to the ON position (as far as you can go without cranking the engine).
      Doors will lock. 

6.      Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to 
       be programmed. After about 15 seconds, the vehicle will respond by locking and 
       unlocking the doors. Release the buttons on the transmitter.

7.      Within one minute, repeat the previous step on the remaining transmitters to be
       programmed.

8.    Remove jumper wire applied to the OBDII Port.

       

   Can I Program an ignition key for this vehicle?
  Yes, Contact us.