Obtain all remote transmitters for this vehicle. FOR FACTORY INSTALLED KEYLESS ENTRY USE THIS PROCEDURE 1. Locate the Wireless Door Lock ECU. It is located towards the front of the center console. With the key out of the ignition and the ECU still connected jump cavity 9 to cavity 1. Cavity 9 will not have a wire going into it while cavity 1 will have a wire going into it. Cavities 2, 3, 6, 7, 9, 12, and 13 will be empty while cavities 1, 4, 5, 8, 10, 11, 14, and 15 will have wires entering the cavities. Ensure when jumping pin 9 to 1 that you make contact with the metal pins in the cavities. Leave jumper wire connected throughout the procedure. 2. Once jumped properly the power door locks will cycle to lock and then unlock. Once vehicle automatically cycles the door locks then vehicle is in programming mode. 3. Press any button on the first remote to be programmed. Vehicle will confirm recognition by once again cycling the door locks. 4. Repeat step 3 for any additional remotes to be programmed to the vehicle. 5. Remove jumper wire from ECU and test remotes to ensure proper programming.